Table of Contents
Advertisement
6 Router Settings
This section is only available for AP Router Mode and Client Router Mode.
6.1 WAN Settings
There are four different types of WAN connection: Static IP, DHCP, PPPoE and PPTP. Please contact
your ISP to select the connection type.
6.1.1 Static IP
Select Static IP in WAN connection if your ISP gives all the information about IP address, Subnet Mask,
Default Gateway, Primary DNS and Secondary DNS.
Internet Connection Type
Account Name
Domain Name
MTU
IP Address
IP Subnet Mask
Gateway IP Address
Primary DNS
Secondary DNS
Discard Ping on WAN
Apply / Cancel
Auction: If the router's MTU is set too high, packets will be fragmented downstream. If the router's
MTU is set too low, the router will fragment packets unnecessarily and in extreme cases may be
unable to establish some connections. In either case, network performance can suffer.
Select Static IP to begin configuration of the Static IP connection.
Specify Account Name that is provided by ISP.
Specify Domain Name that is provided by ISP.
Specify the Maximum Transmit Unit size. Suggest remain in Auto.
Specify WAN port IP address.
Specify WAN IP Subnet Mask.
Specify WAN Gateway IP address.
Specify Primary DNS IP.
Specify Secondary DNS IP.
Place a Check to Enable or Disable ping from WAN.
Press Apply to apply the changes or Cancel to return previous settings.
34
Advertisement
Table of Contents
