EnGenius EOC-2610 Quick Start Manual

EOC-2610
Wireless Access Point & Client Bridge
E
OC-2610 is a long range outdoor wireless Access Point
and Client Bridge that operates seamlessly in the
2.4GHz frequency spectrum. It features high transmitted output
power and high receivable sensitivity along with antenna diversity.
High output power and high sensitivity can extend range and
coverage to reduce the roaming between Access Points to get a more
stable wireless connection. It also reduces the expense of equipment
in the same environment.
This Guide will assist you in setting up the Access Point as quickly as
possible and with the least effort.
IP Address Configuration
The default IP address of the device is
192.168.1.1. In order to log into this device,
you must first configure the TCP/IP settings
of your PC/Notebook.
1. In the control panel, double click
Network Connections and then double
click on the connection of your Network
Interface Card (NIC). You will then see
the following screen.
2. Select Internet Protocol (TCP/IP) and
then click on the Properties button. This
will allow you to configure the TCP/IP
settings of your PC/Notebook.
3. Select Use the following IP Address
radio button and then enter the IP
address (192.168.1.21) and
mask (255.255.255.0). Ensure that the
IP address and subnet mask are on the
same subnet as the device.
4. Click on the OK button to close this
window, and once again to close LAN
properties window.
Logging In
1. To configure the device through the
web-browser, enter the IP address of the
Bridge (default: 192.168.1.1) into the
address bar of the web-browser and
press Enter.
2. After connecting to the IP address, the
web-browser will display the login page.
Quick Start Guide v.1.0
Refer to User's Manual for complete instructions
Specify admin as the default User
Name and Password, and then click on
the Login button.
Administration
1. Click on the Administration link under
the Management section. This option
allows you to create a new user name
and password for the device. For
subnet
security it is highly recommended for
security reasons.
2. Name: Specify a user name into the first
field.
3. Password: Specify a password into this
field and then re-type the password into
the Confirm Password field. Then click
on the Apply button.
4. Click on the Apply button to save the
changes.
System Properties
1. Click on the System Properties link on
the System section. This feature allows
you to configure the device as an Access
Point or Repeater.

Quick Start Guide

1