Vertex Standard VX-351PMR446 Operating Manual page 6

B P I
To install the battery, hold the transceiver with your
left hand, so your palm is over the speaker and your
thumb is on the top of the belt clip. Insert the battery
pack into the battery compartment on the back of the
radio while tilting the Belt Clip outward, then push
the bottom side of the battery pack until the battery
pack locks with the Battery Pack Latch.
To remove the battery, turn the radio off and remove
any protective cases. Slide the Battery Pack Latch on
the bottom of the radio, then slide the battery down-
ward and out from the radio while holding the Belt
Clip.
Page 4
B Y
R B
1. Insert the DC plug from the PA-42
2. Turn the transceiver "off", then insert
Push the bottom side
of the battery pack
3. If the transceiver is inserted correctly, the LED indi-
4. The LED indicator will change to green when charg-
5. When charging is com-
B
C
AC Adapter into the DC jack on the
bottom side of the CD-34 Desktop
Rapid Charger, then plug the PA-42
AC Adapter into the AC line outlet.
the transceiver into the CD-34 Desk-
top Rapid Charger while aligning the slots of the bat-
tery pack with the guides in the nest of the CD-34;
refer to the illustration below for details on proper po-
sitioning of the battery pack.
cator will glow red. A fully-discharged pack will be
charged completely in approximately 2 hours.
ing is nearing completion. The
battery pack becomes fully
charged approximately 30 min-
utes later.
pleted, remove the trans-
ceiver from the CD-34
Desktop Rapid Charger,
and unplug the PA-42 AC
Adapter from the AC line
outlet.
Align the slots of the battery
pack with the guides in the
nest of the CD-34 Desktop
Rapid Charger.