Related Manuals for Datavideo TBC-5000
Summary of Contents for Datavideo TBC-5000
- Page 1 TBC & Matrix Switcher TBC-5000 Instruction Manual www.datavideo-tek.com Rev 150509...
-
Page 2: Table Of Contents
Disposal ..........................4 Packing List ........................4 TBC-5000 Features .................... 4 Product Overview ....................5 TBC-5000 Front Panel ...................... 5 TBC-5000 Rear Panel ....................... 6 Example Set ups ....................8 4/4 mode – 4 in 4 out ......................8 4/2 mode – 4 in 2 out ......................8 4/1 mode –... -
Page 3: Warnings And Precautions
AC adapter. If you are not sure of the type of power available, consult your Datavideo dealer or your local power company. 8. Do not allow anything to rest on the power cord. Do not locate this unit where the power cord will be walked on, rolled over, damaged or otherwise stressed. -
Page 4: Warranty
12 months from the date of product purchase. If this equipment fails due to such defects, Datavideo will, at its option, repair or provide a replacement for the defective part or product. Equipment that fails after the warranty period, has been operated or installed in a manner other than that specified by Datavideo, or has been subjected to abuse or modification, will be repaired for time and material charges at the Buyer’s expense. -
Page 5: Product Overview
House Sync, Genlock or Black Burst Signal Generator. The TBC-5000 is ideal for use in set ups with other products such as the Datavideo DVK-100 stand alone Chromakey solution or with an Analogue to Digital converter or an Analogue Video capture card. -
Page 6: Tbc-5000 Rear Panel
Select PC mode to update Firmware via RS-232 9pin Sub D serial port. MASTER / SLAVE Assign TBC-5000 as Master or Slave when linked to a second TBC-5000 the Slave unit will follow the actions of the Master unit. RS-232 (Select PC mode) 9-pin Sub D serial port standard RS-232 interface. - Page 7 External Gen-Lock Sync Input & Output (BNC loop through) The TBC-5000 will lock on to the input sync signal supplied and use this for synchronization of the connected inputs. The TBC-5000 will also output the supplied sync signal for connection to other equipment.
-
Page 8: Example Set Ups
4/4 mode – 4 in 4 out 4/4 mode fully utilises all 4 of the TBC-5000’s inputs and outputs. All 4 front panel keys will be illuminated red. If 4 video signals are fed into the unit they are stabilised and synchronised but they cannot be switched within the unit. -
Page 9: 4/1 Mode - 4 In 1 Out
3.5mm Jack to Jack GPI cable connected between both units. A TBC-5000 unit set as Master can only control one TBC-5000 unit set as Slave. Only the front panel on the Master unit controls the switching on both Master and Slave units. -
Page 10: Specifications
Specifications Video inputs Y/C & Composite compliant to CCIR601 NTSC & PAL Video Outputs Y/C & Composite Composite Video: 75Ω 1.0 V p-p S-Video (Y/C): 4 Pin Mini Din 75Ω Y: 1.0 V p-p, C: 0.627 mV p-p Bandwidth: > 5.0mHz Video Spec Differential of Gain（DG）＜3％... -
Page 11: Service And Support
It is our goal to make your products ownership a satisfying experience. Our supporting staff is available to assist you in setting up and operating your system. Please refer to our web site www.datavideo-tek.com for answers to common questions, support requests or contact your local office below.