Vertex Standard VX-6000V Service Manual page 24

Transmitter Output Power
The following transmitter parameters can be ad-
justed from the computer by utilizing the Alignment
Software. Refer to the onboard help of the Align-
ment Software Manual for details.
r Select the band center frequency channel (CH2
or CH5), and select the "high" power output level.
Key the transmitter and adjust "TX PWR Hi" for a
power output of 110 Watts (± 3.0 W) as indicated
on the wattmeter.
r Stay on the band center frequency channel (CH2
or CH5), and select the "low" power output level.
Key the transmitter and adjust "TX PWR L3" for
a power level of 50 Watts (± 2.0 W) as indicated
on the wattmeter.
Transmitter Deviation
The following modulation parameters can be ad-
justed from the computer by utilizing the Alignment
Software. Refer to the onboard help of the Align-
ment Software Manual for details.
Microphone Audio Modulation Level
r Select the band center frequency channel (CH2),
and select the "low" power output level.
r Adjust the AF generator for 50mV (–30dBm) out-
put at 1 kHz, as applied to the microphone jack.
r Key the transmitter and adjust "MAX Dev ( wide ) "
for maxi-mum deviation of 4.2 kHz ± 0.2 kHz as
indicated on the deviation meter.
r Select the band center frequency channel (CH5),
and select the "low" power output level.
r Adjustdjust the AF generator for 50mV (–30dBm)
output at 1 kHz, as applied to the microphone
jack.
TC1002 TC1001 TP1008
Alignment
5-3