Programming A Salvoswitching Camera Sequence - Bosch LTC 8555/00 Instruction Manual

26 en | User Information
pressing ON. An identical line will be added to the next step. To delete a step, navigate to the
line and press OFF. To delete all steps below the line you're viewing, press LOCK. (Be careful
with this feature!)
To completely erase a sequence, press LOCK while on the first line of the sequence, and then
press OFF. The sequence is then erased, and programming mode automatically exits.
7.5.17

Programming a SalvoSwitching Camera Sequence

A SalvoSwitching® sequence allows specification of a group of monitors that will switch
together as a synchronized group. To program a salvo sequence, enter the programming mode
as described above for a simple camera sequence. Since a salvo sequence involves multiple
monitors switching as a group, the sequence must involve more than 1 monitor. An example of
a simple salvo sequence that switches cameras on three monitors simultaneously is shown
below in spreadsheet format:
Camera
In general, follow the instructions used for the simple camera sequence described above, but
instead of entering a number of seconds for steps that must switch instantly, enter 61 and
press ENTER. When 61 is entered, the switcher automatically changes to the salvo
abbreviation SLV. Dwell time (in seconds) is entered only upon reaching the step containing
the last monitor to be switched within the synchronized group.
F.01U.127.290 | 2.0 | 2009.03
Monitor
1 1
2 2
3 3
7 1
8 2
9 3
21 1
22 3
23 3
Instruction Manual
Dwell
SLV
SLV
2
SLV
SLV
2
SLV
SLV
2
Allegiant Keyboards
Bosch Security Systems, Inc.