Wiring Configurations - Orion Cobalt CO104S Owner's Manual

WIRING CONFIGURATIONS

The following illustrations provide guidelines on properly connecting your
Orion Cobalt woofer to an Orion Cobalt amplifier for maximum performance.
Recommended Amplifier Power
1 woofer
2 woofers
3 woofers
4 woofers
Parallel—Two Speakers ( 4 ohm voice coils)
Two 4 ohm voice coil woofers with the two woofers in parallel results in a 2 ohm load
to the amplifier..
_
+
Figure 2
Figura 2
Abbildung 2
1. Connect the speaker in parallel by connecting the two positive (+) terminals
together and the two negative (-) terminals together.
2. Wire the positive (+) terminals of the woofers to the positive (+) terminal on
the amplifier. Wire the negative (-) terminals of the woofers to the negative (-)
terminal on the amplifier.
4
Continuous Power (RMS)
100 to 300
200 to 600
300 to 900
400 to 1200
4 ohm
Peak Power (Watts)
200 to 600
400 to 1200
600 to 1800
800 to 2400
_
4 ohm
+
+
_
© 2012 MD Audio Engineering—all rights reserved