Table of Contents
Advertisement
12. Pivot the microprocessor retainer downward to close the retainer.
Figure 51. Closing the microprocessor retainer
13. Gently press down the small handle
down the small handle
and secure the new microprocessor in the socket.
Note: There are two marks on the microprocessor retainer. Ensure that you close the small handle
marked with
correct sequence when you close the small handles.
Figure 52. Securing the microprocessor in the socket
14. Reinstall the heat sink and fan assembly. See "Replacing the heat sink and fan assembly" on page 98.
15. If you are instructed to return the old microprocessor, follow all packaging instructions and use any
packaging materials that are supplied to you for shipping.
16. To complete the replacement, go to "Completing the parts replacement" on page 124.
Replacing the system board
Attention:
Do not open your computer or attempt any repair before reading and understanding the "Important Safety
Information" on page 1.
This section provides instructions on how to replace the system board.
1
, and then push the handle inward to secure it. Then gently press
2
and push the handle inward to lock the microprocessor retainer into position
first, and then close the small handle marked with
. Always follow the
.
Chapter 10
Replacing FRUs
119
Advertisement
Table of Contents
Troubleshooting
