Installation; Connect To Water Supply - Graco Hydra-Clean 2545 Instructions-Parts List Manual

INSTALLATION

Flgure 1
Check for Shipping Damage
Check the unit for any damage that may have occurred
in shipping. Notlfy the carrier Immediately if there is
any damage.
Set Up
If you are using a downstream chemical injector, install
between the pump unloader and the high pressure
hose, using the quick couplers provided.
Connect the high pressure hose between the pump
outlet and the gun inlet. Both of these connections are
made with quick couplers.
oerformance. used.
if
Install the appropriate spray tip on the wand. See
Installing and Changing Spray Tips. If
sandblaster kit, see its separate manual for installation
instructions.
_ _

Connect to Water Supply

' I -
it
water supply. Install it upstream from the pump.
temoerature.
Connect a hose with at least a
the water supply to the unit's
The supply hose should not be more than
long.
you
are using a
NOTE The water source at the unit must have a
~~
CAUTION
Before attaching to the water supply, check your
local plumbing code regarding cross-
connection to the water supply. A backflow
801-133,
preventer, P/N is available to prevent
backflow of contaminated water into the fresh
If inlet water pressure is over
regulating water valve, P/N
installed at the garden hose connection.
Do not exceed F (70" C) inlet water
1 6 0 O
3/4
3/4
minimum flow rate equal to that of the unit (see
Technical Data, inside back cover).
( 4 . 1
60
psi bar) a
800-258,
must be
inch mm) ID from
(19
inch garden hose inlet.
f t ( l 5
m)
50
308-531 5