Section 6-Cleaning; Cleaning Water Reservoir Assembly - Invacare Polaris EX ISP4000 Operator's Manual

SECTION 6—CLEANING
To prevent electrical shock, ALWAYS disconnect the
CPAP power cord before cleaning the humidifier
platform. DO NOT immerse the humidifier platform,
CPAP device or power cord into any fluids.
Allow the water in the reservoir to cool down to room
temperature before removing the water reservoir assem-
bly from the humidifier.

Cleaning Water Reservoir Assembly

Emptying and cleaning the water reservoir assembly daily
will help to prevent mold and bacteria growth.
NOTE: For this procedure, refer to FIGURE 6.1.
1. Turn the CPAP device off and allow approximately 15
minutes for the heater plate and water to cool.
2. Disconnect the six foot flexible tube from the reservoir cap.
3. Press down on the water reservoir assembly and slide it
out of the humidifier platform.
4. Remove the reservoir cap.
5. Discard any remaining water.
Part No 1118358
SECTION 6—CLEANING
WARNING
WARNING
15 Invacare® Polaris™EX™
Heated Humidifier