Makita LS1211 Instruction Manual page 18

When cutting crown and cove moldings, set the bevel angle and miter angle as indicated
in the table ( A ) and position the moldings on the top surface of the saw base as indi-
cated in the table
(B).
Table
( A I
For inside corner
For outside corner
Bevel angle
52/38O type
I
45O type
Molding position
in
Fig. (AI
0
0
0
-
@ I
__
33.90 30°
Molding
in Fig. ( A I
Miter angle
Molding edge against guide fence Finished piece
Left 31.6O Left 35.3"
-
For outside corner
a
Right 31.6O
1
Right 35.3"
Finished piece will be on the
Right side of blade.
Ceiling contact edge should be
against guide fence.
Ceiling contact edge should be
against guide fence.
Finished piece will be on the
Left side of blade.
For inside corner
0
m
Wall
contact edge should be
against guide fence.