Weslo WLEX0996.0 User Manual page 5

4. The Console (7) requires one "AAA" battery (not
included); an alkaline battery is recommended. Refer
to the inset drawing. Remove the battery door from
the back of the Console and insert the battery into
the Console. Make sure that the battery is orient-
ed as shown by the diagram inside the battery
compartment. Then, reattach the battery door.
Next, plug the Reed Switch Wire (28) fully into the
socket on the back of the Console (7).
Slide the Console onto the console plate. Note: The
Console is held by friction; it does not snap into place.
5. Attach the Seat (11) to the Seat Post (10) with four
M8 Nylon Locknuts (9) and four M8 Spring Washers
(8). Note: The Nylon Locknuts and Spring Washers
may be pre-attached to the Seat.
Press the Frame Bushing (4) into the Frame (1).
(Note: The Frame Bushing may be pre-assembled.)
Next, insert the Seat Post (10) into the Frame.
Align one of the holes in the Seat Post (10) with the
hole in the Frame (1). Insert the Seat Pin (31) into
the Frame and the Seat Post. Make sure that the
Seat Pin is inserted into one of the holes in the
Seat Post; do not insert the Seat Pin under the
Seat Post. Tighten the Seat Pin into the Frame.
6. Identify the Right Pedal (22), which is marked with
an "R." Remove only the Right Pedal Nut (47) and
the Pedal Bushing (46) from the Pedal. Next, insert
the shaft of the Pedal into the right Pedal Arm (49).
Slide the Pedal Bushing back onto the Pedal, and
position the Pedal Bushing so that it slides into the
Pedal Arm. Tighten the shaft of the Pedal clockwise
into the right arm of the Crank (20) as firmly as pos-
sible. Tighten the Pedal Nut clockwise onto the
Pedal. Make sure that the Pedal and the Pedal
Nut are tightened as firmly as possible.
Repeat this step to attach the Left Pedal (not
shown), turning the Pedal and the Left Pedal Nut
(not shown) counterclockwise .
7. Make sure that all parts are properly tightened before you use the exercise cycle. Note: Some hard-
ware may be left over after assembly is completed. Place a mat under the exercise cycle to protect the
floor or carpet from damage.
4
Console
5
8
9
31
6
46
44
22
5
7
Plate
Battery
Battery Door
11
8
9
10
4
Hole
1
47
49
20
28