Toyota RS3200 PLUS Owner's Manual page 5

TOYOTA RS3200 P
Page 4
BRIEF DESCRIPTION–RS3200 P
FEATURES
STARTER DISABLE
FORCED LOCK
DURING ALARM
TRIGGER MEMORY
EXTERIOR LIGHT
ACTIVATION
BUZZER ACTIVATION
HORN ACTIVATION
POWER LOSS MEMORY
STATUS MONITOR
IGNITION-CONTROLLED
AUTOMATIC DOOR
LOCK/UNLOCK
* This feature available ONLY IN 4RUNNER. You may disable this feature. Please refer to page
14 for programming information.
Security system
LUS
When an A is T
LARM RIGGERED
starter and prevents engine start until the system is reset (D
During an A , the system will lock the doors if one is unlocked,
LARM
and will continue to do so for the duration of the A
The user is notified that an A
system after an A was T
LARM
lights will be turned on for 2 seconds.
The RS3200 P flashes the vehicle's tail and marker lights during
LUS
R A and R
EMOTE RMING EMOTE
Also, during an A the headlights flash.
LARM
If your vehicle is equipped with a buzzer that chirps when the lock
and unlock buttons on the remote keyless entry system's remote
controls are pressed, the buzzer will also chirp when the system is
R A and D
EMOTE RMED ISARMED
During an A , the RS3200 P
LARM
If power to the RS3200 P
is T once power is restored.
RIGGERED
This panel houses the G
LASS
flashing LED that indicates the operating status of the security system.
(Some vehicle applications utilize the vehicle's engine immobiliser
system LED and a separate microphone, instead.)
The RS3200 P automatically locks your vehicle's doors when you
LUS
turn the ignition key to "ON" or "START", and unlocks the doors when
you turn the key back to "ACC" or "LOCK".*
FEATURES
LUS
FUNCTIONS
, the system disables the vehicle's
occurred. Upon D
LARM
, the vehicle's tail and marker
RIGGERED
D , and during an A
ISARMING
.
activates the vehicle's horn.
LUS
is disrupted while it is A
LUS
B S microphone and the
REAKAGE ENSOR
).
ISARMED
.
LARM
the
ISARMING
.
LARM
, an A
RMED LARM
PROGRAMMIN
The RS3200 P is factory-s
LUS
A operation, as well as
RMING
information on this feature, p
PASSIVE ARMING ON
1. Before you begin:
Close all the doors
Unlock all the doo
Remove the key fro
2. Start the Programming
a. Using the remote control,
lock, then unlock the
doors 3 times.
d. The system locks the doo
in 2 seconds; if this does
not happen, start over.
3. Select the Operating M
a. Close, then Open the doo
2 times = P A
ASSIVE RMING
3 times = P A
ASSIVE RMING
0 Sec. E
NTRY
4 times = P A
ASSIVE RMING
15 Sec. E
5 times = P A
ASSIVE RMING
30 Sec. E
D
NTRY
NTRY