Shifting Between “H4” And “L4” - Toyota Tacoma 2005 Operating Manual

05 02.25
SHIFTING BETWEEN "H4" AND "L4"
To shift from "H4" to "L4", stop the
vehicle or reduce the vehicle speed to
less than 3 km/h (2 mph). With your foot
off the accelerator pedal, depress the
clutch pedal and push and turn the front
drive control switch knob fully clockwise.
To shift from "L4" to "H4", stop the
vehicle or reduce the vehicle speed to
less than 3 km/h (2 mph). With your foot
off the accelerator pedal, depress the
clutch pedal and turn the front drive con-
trol switch knob fully counterclockwise.
If the "4LO" (low speed four- wheel drive)
indicator light continues to blink when you
operate the front drive control switch knob
to the "H4" or "L4" position, drive forward
or backward in a short distance, then stop
the vehicle completely, depress the clutch
pedal and operate the switch knob again.
If the indicator continues to blink even if
doing so, contact your Toyota dealer as
soon as possible. There may be a trouble
in the four- wheel drive system.
CAUTION
Never operate the front drive control
switch knob if the wheels are slip-
ping. Stop the slipping or spinning
before operating.
2005 TACOMA from Mar. '05 Prod. (OM35862U)
(c) Shifting procedure (with
automatic transmission)
SHIFTING BETWEEN "H2" AND "H4"
To shift from "H2" to "H4", reduce the
vehicle speed to less than 100 km/h (62
mph) and turn the front drive control
switch knob fully clockwise.
If the four- wheel drive indicator light con-
tinues to blink when you operate the front
drive control switch knob from the "H2" to
the "H4" position, this reminds you that
the transfer mode is not securely in "H4"
mode. Drive straight ahead while acceler-
ating or decelerating.
If the four- wheel drive indicator light con-
tinues to blink and the buzzer sounds
when you operate the front drive control
switch knob from the "H2" to the "H4"
position, this reminds you that the transfer
mode is not in "H4" mode. Stop the ve-
hicle or reduce the vehicle speed to less
than 100 km/h (62 mph). Operate the
switch knob again.
CAUTION
Never operate the front drive control
switch knob if the wheels are slip-
ping. Stop the slipping or spinning
before operating.
171