Assembly; Packaging List; Wheel & Handle Kit Assembly Installation - GMC Yukon Owner's Manual

ASSEMBLY

Packaging List

CAUTION
Generator is heavy! Lifting generator can
cause back or other bodily injury.
NEVER lift generator without assistance.
Generator
Wheel & Handle Kit Assembly
Wheel axle (1)
Wheel (2)
Bolt M8X16 (6)
Nut M8 (8)
Washer (2)
Split pin (2)
Axle holder (2)
Battery Cage Kit Assembly
Battery guard plate (1)
Battery bracket (2)
Fixing screw (2)
Cushion (1)
Battery tray (1)
Starter cable - positive
lead cable (1)
Starter cable - positive
lead boot (1)
Ground cable - negative
lead cable (1)
Bolt M6X20 (2)
Sky Hook Assembly
Rubber sleeves (2)
Holding plate (2)
Bolt M8x20 (4)
1 L Engine Oil
Tool Kit
Owners Manual
Wireless Remote Control
10
Stand (2)
Connecting block (2)
Handles (2)
Handle sleeves (2)
Bolt M8X40 (2)
Cotter pin (2)
Nut M6 (2)
Battery guard - side
frame (2)
Arc pad (8)
Wire clamp (1)
Nut M6X (12)
Bolt M6X12 (4)
Bolt M6X30 (8)
Bolt M8X16 (2)
Nut M8 (2)
Customer Support: 1-866-409-4581
Wheel & Handle Kit Assembly
Installation
CAUTION
Keep all hands and fingers away from hinges when
folding down the handles.
NOTICE
Never use this wheel kit with any other product.
Never pull your generator with a vehicle or use on a
road.
1. Slide the wheels (5) over the axle (4) on both ends, then slide
on the two washers (8) and insert the two split pins (9) into the
axle and spread apart.
2. Mount assembled axle (4) to the frame with axle holder (10),
bolt (6) and nut (7). Refer to diagram #1.
3. Fit the two stands (11) on the frame with the two bolts (6) and
nuts (7).
4. Fit the two handles (13) on the connecting block (12) with the
two bolts (15) and nuts (7), then mount the assembled handle
on the frame. Use the two cotter pins (16) to hold handles in
an upright position.
15
12
16
7
13
6
7
7
9
8
5
10
7
1. Mounting axle 7. Nut M8 (8)
diagram
8. Washer (2)
2. Shorter end
9. Split pin (2)
3. Longer end
10. Axle holder (2)
4. Wheel axle (1)
11. Stand (2)
5. Wheel (2)
6. Bolt M8X16 (6)
GENERATOR
7
14
6
#1
11
3
6
4
8
7
9
12. Connecting
block (2)
13. Handle (2)
14. Handle
sleeves (2)
15. Bolt M8X40 (2)
16. Cotter pins (2)
16
2