Remaining Running Time Display; Timer Programming; End Of Programme; Switching Off The Appliance - Siemens SN25E230EA Instructions For Use Manual

en

Remaining running time display

When the programme is selected, the
remaining running time of the programme
is indicated on the digital display
The running time is determined during the
programme by the water temperature, the
number of utensils as well as the degree
of soiling and may vary (depending on the
selected programme).

Timer programming *

* depending on model
You can delay the start of the programme
in 1-hour steps up to 24 hours.
Close the door.
Switch on ON/OFF switch
Press button until the digital
6
display jumps to
5
Press button
6
time corresponds with your
requirements.
Press Start button
timer programming is activated.
To delete the preselected starting time,
press the button
indicated on the digital display.
You can change your programme
selection at any time until the
programme starts.

End of programme

The programme has ended when the
value is indicated on the numerical
display .
5
16
.
5
.
1
.
until the displayed
,
4
until is
6

Switching off the appliance

Short time after the end of the programme:
Switch off ON/OFF switch
Turn off the tap (not applicable
if Aqua-Stop fitted).
Remove the utensils when they
have cooled down.
Warning
At the end of the programme please open
the door fully and not partially when
emptying the dishwasher. Any escaping
water vapour could damage sensitive
worktops.

Interrupting the programme

Switch off ON/OFF switch
The LEDs go out. The programme
is saved.
If the door was opened on an appliance
which has a warm water connection or
is heated, first leave the door ajar for
several minutes and then close.
Otherwise, expansion (pressure) may
cause the appliance door to spring
open or water to run out of the
appliance.
To continue the programme, switch on
the ON/OFF switch
Terminating the programme
(Reset)
Press START button
3 sec.
The numerical display
.
The programme sequence lasts
approx. 1 min.
On the digital display
.
Switch off ON/OFF switch
.
1
.
1
again.
1
for approx.
4
indicates
5
is indicated
5
.
1