Advertisement
Quick Links
Jumper Settings
Stand Alone (Default)
Master with Slave Present
Slave to Master
Cable Select *
X= PK is a Parking position. The presence or absence of this jumper has no effect on the drive. Labeling may
indicate to place this jumper when configuring as a slave. This is to provide for retention of the jumper in the
event that it is needed later.
*Note: Cable Select (CS) utilizes a special cable configuration where the drive setting (Master or Slave) is
determined by its position on the 40-pin ATA cable. In this type of configuration both drives will have their
jumper set to CS. Cable Select is utilized on some OEM systems and is typically required for systems utilizing
Ultra ATA/66. For Ultra ATA/66 compliant cables, the master drive is placed on the outside (end) cable
connector and the slave drive is placed
1 of 1
Fireball lct10
fireball_lct10_jumper.pdf
DS
CS
PK
ON
OFF
X
ON
OFF
X
OFF
OFF
X
OFF
ON
X
on the intermediate cable connector.
Rsvd
OFF
OFF
OFF
OFF
Advertisement
Related Manuals for Quantum Maxtor Fireball lct10
Summary of Contents for Quantum Maxtor Fireball lct10
- Page 1 Fireball lct10 fireball_lct10_jumper.pdf Jumper Settings Rsvd Stand Alone (Default) Master with Slave Present Slave to Master Cable Select * X= PK is a Parking position. The presence or absence of this jumper has no effect on the drive. Labeling may indicate to place this jumper when configuring as a slave.
- Page 2 ATA / IDE cable connector. Using the jumper pins you can establish the drive Master/Slave configuration. The Maxtor Fireball lct10 was developed by Quantum Corporation prior to its merger with Maxtor. BIOS Settings The following BIOS parameters are provided for customers needing to manually configure the Fireball lct10 disk drive.
- Page 3 Fireball lct10 fireball_lct10_jumper.pdf Special Considerations BIOS/Operating System Limitations Hard drives greater than 2.1GB may need to be divided into multiple partitions / logical drives. MS-DOS versions 4.0 through 6.22 allow a maximum primary partition / logical drive size of 2.1GB and are limited to 8.4GB in physical drive capacity.