Opel COMBO Owner's Manual page 148

146 Vehicle care
8. Set the rocker switch on the
compressor to I. The tyre is filled
with sealant.
9. All of the sealant is pumped into
the tyre. Then the tyre is inflated.
Tyre pressure 3 174. When the
correct pressure is obtained,
switch off the compressor.
10. If a pressure of 1.5 bar is not
obtained within 5 minutes,
remove the tyre repair kit. Move
the vehicle one tyre rotation.
Reattach the tyre repair kit and
continue the filling procedure for
5 minutes. If a pressure of
1.8 bar is still not obtained within
5 minutes, the tyre is too badly
damaged. Seek the assistance of
a workshop.
Do not run the compressor longer
than 20 minutes.
11. Detach the tyre repair kit.
12. Remove any excess sealant
using a cloth.
13. Take the label indicating
maximum permitted speed from
the sealant bottle and affix in the
driver's field of view.
14. Continue driving immediately so
that sealant is evenly distributed
in the tyre. After driving approx.
10 km (but no more than
10 minutes), stop and check tyre
pressure. Screw compressor air
hose directly onto tyre valve and
compressor when doing this.
If tyre pressure is more than
1.8 bar, set it to the correct value.
Repeat the procedure until there
is no more loss of pressure.
If the tyre pressure has fallen
below 1.8 bar, the vehicle must
not be used. Seek the assistance
of a workshop.
15. Stow away tyre repair kit in load
compartment.