Sunbeam GrindFresh EM0440 Instruction Booklet page 10

Care and Cleaning (continued)
4.Lift and remove bean hopper and collar
from base. Then pull the bean hopper away
from the collar to detach the two pieces
and clean using the burr-cleaning brush.
5.Clean the bottom burr using the burr-
cleaning brush, see figure 9.
Figure 9
NOTE: Any loose beans sitting on the bottom
burr can be removed by either turning the
grinder base upside down and letting them
fall into a bin or alternatively use a vacuum
to remove any beans.
6.Once both the burrs are cleaned, return the
collar to the grinder base by aligning the
notch on the collar with the arrow on the
rear of the grinder base. See figure 10.
Figure 10
8
7.Attach the bean hopper by aligning the
notches on the base of the hopper with the
guides on the inside of the collar. Position
until the hopper sits flat. See figure 11
8.Turn the collar clockwise until the
'UNLOCK' button clicks.
Adjusting the burrs for wear
The conical burrs are made of tool
hardened steel for extra long life. However
after prolonged use the burrs will require
adjustment to compensate for wear. A sign of
this is when the grinds are not as fine as they
used to be, check by rubbing some of the
grinds between two fingers or for espresso the
extraction will also show signs that the grind
needs adjusting.
Replacing the burrs
To inquire about having the burrs replaced
contact the Sunbeam Consumer Hotline on
Australia
1300 881 861
New Zealand
0800 786 232
Figure 11