Related Manuals for Sunbeam GrindFresh EM0440
Summary of Contents for Sunbeam GrindFresh EM0440
- Page 1 GrindFresh Conical Burr Coffee Grinder Instruction Booklet EM0440 Please read these instructions carefully and retain for future reference.
-
Page 2: Table Of Contents
Contents Sunbeam’s Safety Precautions Features of your coffee grinder Operating your coffee grinder Adjusting the Grind Setting Care and Cleaning Important instructions – retain for future use. -
Page 3: Sunbeam's Safety Precautions
If you have any concerns regarding the performance and use of your appliance, please visit www.sunbeam.com.au or contact the Sunbeam Consumer Service Line. Ensure the above safety precautions are understood. -
Page 4: Features Of Your Coffee Grinder
Features of your Coffee Grinder 250g Bean hopper Grind adjustment collar Large and easy to use, the collar has a wide- range of 25 grind settings. The coffee maker can select a fine grind to suit commercial espresso or adjust the setting for other brewing styles – from Turkish to plunger. - Page 5 Burr shield Italian conical burrs Italian designed and manufactured, the metal conical burr design achieves excellent grind consistency and minimises heat transfer to the coffee due to the slowly rotating burrs. Group handle locator Cord stuff Hides away unwanted cord to keep bench top clean.
-
Page 6: Operating Your Coffee Grinder
Heading Operating your coffee grinder Before using the coffee grinder, wipe the 3.Now attach the bean hopper. Insert the base exterior with a damp cloth. Wash the bean hopper by aligning the notches on bean hopper, hopper lid and ground coffee the base of the hopper with the guides on container in warm soapy water, then rinse the inside of the collar. - Page 7 Heading Operating your coffee grinder (continued) 10. To grind coffee, press the group handle 8.Select the grind by turning the grind adjustment collar to the desired setting, against the button located in the centre of the group handle locator, see figure 6. see figure 4.
-
Page 8: Adjusting The Grind Setting
Heading Adjusting the Grind Setting A starting point for grind settings: 2. For drip filter coffee machines, a good starting point is to use 8 grams (1 scoop) SETTING BREWING METHOD of coffee for every 4 cups of brew water as measured with the carafe. -
Page 9: Care And Cleaning
Care and Cleaning Important Notes: 2.To remove the bean hopper with top burr and collar from the grinder base, turn the • Spots and marks on the surface of the collar anti-clockwise until it stops. burrs are part of the hardening process. See figure 7. - Page 10 Replacing the burrs rear of the grinder base. See figure 10. To inquire about having the burrs replaced contact the Sunbeam Consumer Hotline on Australia 1300 881 861 New Zealand 0800 786 232...
- Page 11 You are also Alternatively, you can send a written claim entitled to have the goods repaired or to Sunbeam at the address listed below. replaced if the goods fail to be of acceptable On receipt of your claim, Sunbeam will...
- Page 12 Sunbeam Corporation Limited 2012. ABN 45 000 006 771 Units 5 & 6, 13 Lord Street Botany NSW 2019 Australia Unit 3, Building D 26 Vestey Drive Mt Wellington Auckland New Zealand Sunbeam Corporation is a division of GUD Holdings Ltd. 1/12...