Trunk Configuration - GE -DS-242-POE User Manual

Trunk Configuration

Trunk allows the switch to combine ports so that they function like a single high-
speed link. It can be used to increase the bandwidth to some devices to provide a
high-speed link. For example, trunk is useful when making connections between
switches or connecting servers to the switch. Trunk can also provide a redundant link
for fault tolerance. If one link in the trunk failed, the switch can balance the traffic
among the remaining links.
NOTE: The 10/100 Mbps port cannot be trunked with gigabit port (port 25~26). All
ports in the same trunk group will be treated as a single port. If a trunk group exists,
the ports belonging to that trunk will be replaced by "TRUNK #" in the VLAN
configuration screen. The following example configures port 25~26 as "TRUNK 1."
Trunking Commands
show trunks
Description:
Show trunking information.
Switch(config)# show trunk
Group ID | LACP | Ports | LACP Active
--------------+--------+-------------------+-----------------
1 | Yes | 23,24 |
trunk add
Description:
Add a new trunk group.
Syntax:
trunk add <trunk-id> <lacp | no-lacp> <port-list> <active-port-list>
Parameters:
<trunk-id> specifies the trunk group to be added.
GE-DS-242-PoE Managed Ethernet Switch User Manual
23,24
Chapter 6: Command Line Interface
135