Electrical Requirements - DeLonghi DRAGON HM3 Instructions Manual

Warning - this appliance
must be earthed
Green and Yellow to Earth
13 amp
Fuse
Brown
to Live
Blue to
Cord Clamp
Neutral
Dragon HM3
IMPORTANT INFORMATION FOR CORRECT DISPOSAL OF THE
PRODUCT IN ACCORDANCE WITH EC DIRECTIVE 2002/96/EC.
At the end of its working life, the product must not be disposed of as
urban waste. It must be taken to a special local authority differentiated
waste collection centre or to a dealer providing this service. Disposing
of a household appliance separately avoids possible negative conse-
quences for the environment and health deriving from inappropriate
disposal and enables the constituent materials to be recovered to
obtain significant savings in energy and resources.As a reminder of the need
to dispose of household appliances separately, the product is marked with a
crossed-out wheeled dustbin.

Electrical requirements

Before using this appliance ensure that the voltage indicated on the
product corresponds with the main voltage in your home, if you are in
any doubt about your supply contact your local electricity company.
The flexible mains lead is supplied connected to a B.S. 1363 fused plug having a
fuse of 13 amp capacity. Should this plug not fit the socket outlets in your home,
it should be cut off and replaced with a suitable plug, following the procedure
outlined below.
Note: Such a plug cannot be used for any other appliance and should therefore
be properly disposed of and not left where children might find it and plug it into
a supply socket - with the obvious consequent danger.
N.B. We recommend the use of good quality plugs and wall sockets that can be
switched off when the machine is not in use. important: the wires in the mains
lead fitted to this appliance are coloured in accordance with the following code:
GREEN AND YELLOW
BLUE
BROWN
As the colours of the wires in the mains lead of this appliance may not corre-
spond with the coloured markings identifying the terminals in your plug, proceed
as follows:
The wire which is coloured green and yellow must be connected to the termi-
nal in the plug which is marked with the letter E or by the earth symbol
coloured green or green and yellow. The wire which is coloured blue must be
connected to the terminal which is marked with the letter N or coloured black.
The wire which is coloured brown must be connected to the terminal which is
marked with the letter L or coloured red. When wiring the plug, ensure that all
strands of wire are securely retained in each terminal. Do not forget to tighten
the mains lead clamp on the plug. If your electricity supply point has only two pin
socket outlets, or if you are in doubt, consult a qualified electrician. Should the
mains lead ever require replacement, it is essential that this operation be carried
out by a qualified electrician and should only be replaced with a flexible cord of
the same size. After replacement of a fuse in the plug, the fuse cover must be
refitted. If the fuse cover is lost, the plug must not be used until a replacement
cover is obtained. The colour of the correct replacement fuse cover is that of
the coloured insert in the base of the fuse recess or elsewhere on the plug.
Always state this colour when ordering a replacement fuse cover.
Only 13amp replacement fuses which are asta approved to B.S. 1362 should be
fitted. This appliance conforms to the Norms EN 55014 regarding the suppres-
sion of radio interference.
EARTH
NEUTRAL
LIVE
5
or