Table of Contents
Advertisement
Appendix
Change the Fuse in the
Vehicle Power Cable
CaUTiOn: When replacing the
fuse, do not lose any of the small
pieces and make sure they are put
back in the proper position.
If your device does not charge
in your vehicle, you may need to
replace the fuse located at the tip of
the vehicle adapter.
1. Unscrew the end piece, and
remove it.
2. Remove the fuse (glass and silver
cylinder), and replace with a 1A
fast blow fuse of the same size.
3. Ensure that
the silver tip
is located in
the end piece.
Screw on the
end piece.
0
Mount on Your
Dashboard
A mounting disk is included in
some nüvifone packages. Use the
mounting disk to mount your device
to the dashboard and comply with
certain state and local regulations.
1. Clean and dry the dashboard
where you are placing the disk.
2. Remove the backing from the
adhesive on the bottom of the
disk.
End
End
3. Place the disk on the dashboard.
piece
piece
4. Remove the clear plastic cover
Silver tip
Silver tip
from the top of the disk.
Fuse
Fuse
5. Place the suction cup mount
on top of the disk. Flip the lever
down (toward the disk).
CaUTiOn: The permanent
mounting adhesive is extremely
difficult to remove after it is
installed.
nüvifone M20 Owner's Manual
Advertisement
Table of Contents
