Technical Data; Installation - Electrolux EUC31305W User Manual

As much as the advice does not lead to result, call the nearest brand-mark service.
Replacing the lamp
1. Disconnect the appliance from the power
socket.
2. Disassemble the lamp by using a screw-
driver in the recess on the lamp insert.
3. Assemble a new lamp by guiding it into a
centred position and press until it snaps.
Use a halogen bulb of the same type,
maximum rating of 20 W
4. Reconnect the appliance.

Technical data

Dimension
Rising Time
The technical information are situated in the
rating plate on the internal left side of the ap-
pliance and in the energy label.

Installation

Read the "Safety Information" carefully
for your safety and correct operation of
the appliance before installing the
appliance.
Location
To ensure best performance, if the appliance
is positioned below an overhanging wall unit,
the minimum distance between the top of the
cabinet and the wall unit must be at least 40
mm . Ideally, however, the appliance should
not be positioned below overhanging wall
units.
Height
Width
Depth
Closing the door
1. Clean the door gaskets.
2. If necessary, adjust the door. Refer to "In-
stallation".
3. If necessary, replace the defective door
gaskets. Contact the Service Center.
EUC31305W
1800 mm
595 mm
623 mm
18 h
If the cabinet is placed in a corner and the
side with the hinges facing the wall, the dis-
tance between the wall and the cabinet must
be at least 60 mm to allow the door to open
enough so that the equipment can be re-
moved.
The ventilation space can be:
• directly above the appliance
• behind and above the top cupboard.
In this case, the space behind the top cup-
board must be at least 50 mm deep.
electrolux 11
EUC31305X
1800 mm
595 mm
623 mm
18 h