Low Battery Indication - Graco Ultra Clear 2L01VIB Owner's Manual

Parent Unit
• If operated too long on a low battery, you may also experience a poor signal and the
Power LED on the front of the parent unit may change from green to red.
• You may either turn off the unit, plug in the A/C adapter.
Out of Range Indication
• If the Parent Unit begins to lose the signal from the Nursery Unit you may
hear static or other noise. Immediately move the Parent Unit closer to the
Nursery Unit to regain connection.
***Note: It is not uncommon for the Parent Unit to occasionally
lose and regain connection with the Nursery Unit in
environments that have a significant amount of obstructions.
1. For optimum operation, it is best to use new batteries in the Parent Unit.
2. Place the Nursery Unit within 10 feet (3 meters) of your baby. Plug an AC adapter into
the jack on the side of the Nursery Unit. Plug it into a working 120 volt AC outlet.
3. Aim the Nursery Unit toward your baby. Check that there are no walls or large objects
that could block sound transmission.
4. Set both the Nursery Unit and Parent Unit to the same channel, "A" or "B" ("X" or
"Y").
5. Turn on the Nursery Unit using the On/Off switch on the side. The green power light
should come on.
6. Place the Parent Unit within five (5) feet (1.5 meters) of the Nursery Unit and turn on
the Parent Unit using the On/Off switch on the side of the unit. The green power light
should come on.
7. If you have 2 Parent Units, repeat same set-up procedure for 2
continue to Step 8.
8. Your monitor is now ready for use.

Low Battery Indication

Setting Up the Baby Monitor
4
nd
Parent Unit if not