AEG FAVORIT 44070 i User Information page 23

Malfunction
The programme indicator for
the selected dishwashing cy-
cle is flashing,
the indicator for the end of
the dishwashing cycle is
flashing in sequence 1 short
light signal with approx. 3
second pause in-between:
(Problems with water inlet)
The programme indicator for
the selected dishwashing cy-
cle is flashing,
the indicator for the end of
the dishwashing cycle is
flashing in sequence 2 short
light signals one after anoth-
er.
the indicator for the end of
the dishwashing cycle is
flashing in sequence 3 short
light signals one after anoth-
er.
The cycle is not starting.
Possible cause
The tap is blocked or furred
with lime-scale.
The tap is turned off.
The filter (where present) in
the threaded hose fitting on
the tap is blocked.
Filters in the base of the
washing compartment are
blocked.
Water inlet hose has not
been correctly positioned.
The sink spigot connection
is blocked.
Water drain hose has not
been correctly positioned.
The anti-flood system has
been triggered.
The mains plug is not
plugged in.
A fuse in the house's wiring
system is defective.
For dishwasher models with
a delay start timer:
A start time has been select-
ed.
Remedy
Clean tap.
Turn the tap on.
Clean the filter in the
threaded hose fitting.
Press the button for the
dishwashing cycle that
has started;
then cancel the dish-
washing cycle (see sec-
tion: Starting a
dishwashing cycle);
clean filters (see section:
Cleaning the filters).
Check hose installation.
Clean the sink spigot
outlet.
Check hose installation.
Turn off the tap and
contact the Service
Force Centre.
Plug in mains plug.
Replace fuse.
If the dishes are to be
washed immediately,
cancel the delay start.
23