Setting The Gear Change Pedal; Setting The Rear Brake Pedal - Ducati MH900 EVOLUZIONE Owner's Manual

Setting the gear change pedal (fig. 11.2)
The gear change and rear brake pedals can be adjusted
to suit the preferred riding position of each rider.
To set the gear change pedal,
lock linkage (1) and loosen the check nuts (2) and (3).
Note
Nut (2) has a left-hand thread.
E
Rotate linkage (1) until setting the gear change pedal in
the desired position.
Tighten both check nuts onto linkage.
Setting the rear brake pedal (fig. 11.3)
To set the rear brake pedal,
loosen check nut (4).
Turn the pedal travel adjusting screw (5) until pedal is in
the desired position.
Tighten check nut (4).
Work pedal by hand to make sure it has 1.5 - 2 mm free
play before brake begins to bite.
If not so, set the length of master cylinder linkage as
follows.
Loosen the check nut (6) on master cylinder linkage.
Tighten linkage into fork (7) to increase play, or unscrew
linkage to reduce it.
Tighten check nut (6) and check pedal free play again.
18
3
1
2
fig. 11.2
6
7
4
5
fig. 11.3