High Beam Adjustment - Polaris 2004 SPORTSMAN Owner's Manual

MAINTENANCE AND LUBRICATION
Lights

High Beam Adjustment

The headlight beam can be adjusted to any position desired by turning
the adjusting knob on the bottom right side of the headlight pod.
1. Position the vehicle on a level surface with the headlight
approximately 25 ft. (7.6 m) from a wall.
2. Measure the distance from the floor to the center of the headlight
and make a mark on the wall at the same height.
3. Start the engine and turn the headlight switch to high beam.
4. Observe the headlight aim on the wall. The most intense part of
the headlight beam should be aimed two inches (5.1 cm) below the
mark placed on the wall. NOTE: Include rider weight on the seat
when measuring.
5. Adjust the beam to the desired position by turning the adjustment
knob either clockwise or counterclockwise.
Position
knob in
slot and
secure in
locking
tabs
98
Adjustment
Knob Stop
Snap pins
into tabs
Route plug
over handlebar
Slip o-ring
over pin