Table of Contents
Advertisement
5-6
Installing Memory Modules
Note: Check the Supermicro web site for recommended memory modules.
Exercise extreme care when installing or removing DIMM
Installing & Removing DIMMs
1.
Insert the desired number of DIMMs into the memory
slots, starting with DIMM #1A. For best performance,
please use the memory modules of the same type
and same speed in the same bank. See the DIMM
Installation Chart on the following page.
Note: you must remove the riser card to insert/re-
move a DIMM into slot 1A.
2.
Press down the release tabs on the ends of a
memory slot. Insert each DIMM module vertically into
its slot. Pay attention to the notch along the bottom
of the module to prevent inserting the DIMM module
incorrectly.
3.
Gently press down on the DIMM module until it snaps
into place in the slot. Repeat for all modules.
4.
Reverse the steps above to remove the DIMM mod-
ules from the motherboard.
To Install: Insert module
vertically and press
down until it snaps into
place. Pay attention to
the alignment notch at
the bottom.
To Remove:
Use your thumbs to
gently push the release
tabs near both ends of
the module. This should
release it from the slot.
Chapter 5: Advanced Serverboard Setup
CAUTION
modules to prevent any possible damage.
Figure 5-3. DIMM Installation
Notch
Release Tab
Top View of DDR3 Slot
5-9
Press down the release tabs
Insert & press down a
DIMM module into the slot
Front View
Note: Notch should align
with the receptive key
point on the slot.
Release Tab
Notch
Advertisement
Table of Contents
