AT&T TRIMLINE 210 User Manual
  1. Manuals
  2. Brands
  3. AT&T Manuals
  4. Telephone
  5. TRIMLINE 210
  6. User manual

AT&T TRIMLINE 210 User Manual

Memory telephone
Hide thumbs Also See for TRIMLINE 210:

Advertisement

Table of Contents

USER'S MANUAL
Part 2
AT&T and the globe symbol are registered trademarks of AT&T Corp.
licensed to Advanced American Telephones.
© 2000 Advanced American Telephones. All rights reserved.
Printed in China. 850005208 Issue 2AT&T 12/00
TRIMLINE
Memory
Telephone 210
Please also read Part 1 —
Important Product Information.
®

Advertisement

Table of Contents
loading

Related Manuals for AT&T TRIMLINE 210

Summary of Contents for AT&T TRIMLINE 210

  • Page 1 USER’S MANUAL Part 2 ® TRIMLINE Memory Telephone 210 Please also read Part 1 — Important Product Information. AT&T and the globe symbol are registered trademarks of AT&T Corp. licensed to Advanced American Telephones. © 2000 Advanced American Telephones. All rights reserved.
  • Page 2 TABLE/DESK INSTALLATION This telephone includes a 7-foot line cord with a modular plug on each end. Use this cord to connect the telephone to a modular jack. 1 Fill in directory card Remove the directory card and write in your own telephone number.

  • Page 3: Wall Installation

    WALL INSTALLATION 1 Fill in directory card Remove the directory card and write in your own telephone number. Also write the telephone numbers (or names) that you want to store in each memory location. 2 Reverse handset tab To install the telephone on a wall jack, you must reverse the small tab beneath the directory card.
  • Page 4 4 Install telephone base on wall jack Hold the base up next to the wall jack, and plug in the line cord (Figure 3). Then push the base against the wall jack and down until it is held securely by the mounting studs.

  • Page 5: Operation

    OPERATION Redial This telephone stores in memory the last phone number dialed. However, if the phone is unplugged from the line jack for 30 minutes or more, redial memory will be lost. The redial memory can accept numbers up to 31 digits long.

  • Page 6: Ringer Volume

    Mute While on a call, press PROG/MUTE to mute the microphone. The other party cannot hear you, but you can hear the other party. Press PROG/MUTE again to return to two-way conversation. Ringer Volume The RINGER volume switch allows you to turn the telephone ringer OFF, or set it to ring at LO or HI volume.

  • Page 7: Temporary Tone Dialing

    Temporary Tone Dialing Temporary tone dialing is used only when you have rotary service. It allows you access to services that require tone signaling, including some tone-activated computer systems (e.g., telephone banking). To change from pulse (rotary) to tone dialing during a call: 1 Dial a telephone number with the DIAL switch set to DP (pulse).

  • Page 8: Memory Dialing

    MEMORY DIALING Memory Features This telephone can store up to 13 different phone numbers, each up to 21 digits long. Numbers will remain stored in memory unless you erase or change them by entering other numbers. NOTE: Numbers programmed into a memory location might not be retained if the telephone has been unplugged from the line jack for a half hour or more.

  • Page 9: One-Touch Dialing

    One-Touch Dialing Three numbers can be stored in one-touch memory locations . You can dial these numbers by pressing one of the buttons marked with an emergency symbol To program numbers into memory 1 Lift the handset. 3 Press the 2 Press one-touch PROG/MUTE...

  • Page 10: Memory Erase

    Speed Dialing Ten telephone numbers can be stored in standard speed-dialing locations. You can dial any of these numbers by pressing two buttons. To program numbers into memory 1 Lift the handset. 2 Press PROG/MUTE 3 Press 4 Enter a digit (0-9) for the memory location where the number is to be stored.

  • Page 11: In Case Of Difficulty

    IN CASE OF DIFFICULTY If you have difficulty operating this phone, try the suggestions below. For Customer Service, visit our website at www.telephones.att.com or call 1 800 222-3111. Please retain your receipt as your proof of purchase. No Dial Tone •...
  • Page 12 Telephone Does Not Ring • Make sure the RINGER volume switch is not set to OFF. • You may have inadvertently turned off the ringer. Press PROG/MUTE PROG/MUTE • If there are several other phones on the same line, try disconnecting some of the other telephones.

Table of Contents