Accessories - GoVideo Sonic Blue DVP855 User Manual

Accessories

Accessories
User's Manual
Remote controller
Install Batteries in the
Remote
1
Remove the battery
Compartment
cover
2
Insert two 'AA' Alkaline batteries
make sure that the batteries
are inserted with their
positive and negative
poles positioned correctly.
3
Close the cover until
it clicks
37
Batteries (2 AA size batteries)
1 Audio/video connection cable
If remote doesn't operate
properly:
Check the polarity + - of the
batteries (Dry-Cell)
Check if the batteries are
drained.
Check if remote sensor is
blocked by obstacles.
Check if there is any
fluorescent lighting nearby.
Troubleshooting Guide
Check the ollowing guide for the possible cause of a problem before contacting
service.
Symptom Cause
No power. The power cord is disconnected.
The power is on, No disc is inserted.
but the DVD player
does not work.
No picture. The TV is not set to receive DVD
signal output
The video cable is not connected
securely.
The connected TV power is turned off.
No sound. The equipment connected with the
audio cable is not set to receive DVD
signal output.
The audio cables are not connected
securely.
The power of the equipment connected
with the audio cable is turned off.
The digital Audio Output is set to the
wrong position.
The playback picture is poor. The disc is dirty.
The DVD player No disc is inserted.
does not start
playback.
An unplayable disc is inserted.
The disc is placed upside down.
The disc is not placed within the guide.
The disc is dirty.
A menu is on the TV screen.
The Rating level is set.
The remote The remote control is not pointed at the
control does not remote sensor of the DVD player.
work properly.
The remote control is too far from the
DVD player.
There is an obstacle in the path of the
remote control and the DVD player.
The batteries in the remote control are
exhausted.
Correction
Plug the power cord into the wall outlet
securely.
Insert a disc. (Check that the DVD or,
audio CD indicator in the DVD display is lit.)
Select the appropriatevideo input mode
on the TV so the picture from the DVD
player appears on the TV screen.
Connect the video cable into the jacks
securely.
Turn on the TV.
Select the correct input mode of the
audio receiver so you can listen to the
sound from the DVD player.
Connect the audio cable into the jacks
securely.
Turn on the equipment connected with
the audio cable.
Set the Digital Audio Output to the
correct position, then turn on the DVD
player again by pressing the POWER
button.
Clean the disc.
Insert a disc.(Check that the DVD, or
audio CD indicator in the DVD display is lit.)
Insert a playable disc.(Check the disc
type, color system and Regional code.)
Place the disc with the playback side
down.
Place the disc on the disc tray correctly
inside the guide.
Clean the disc.
Press the SETUP button to turn off the
menu screen.
Cancel the Rating function or change
the rating level.
Point the remote control at the remote
sensor of the DVD player.
Operate the remote control within about
23 ft (7m).
Remove the obstacle.
Replace the batteries with new ones.
38