Table of Contents
Advertisement
A. Jack
B. Wheel Blocks
C. Wing Nut
1. Attach the wheel blocks (B) to
the jack (A) with the wheel block
retainer and the wing nut (C).
2. Reinstall the jack and wheel
block assembly in the mounting
bracket. Make sure to position
the holes in the base of the jack
onto the pins in the mounting
bracket.
3. Turn the handle to raise the jack
until it is secure, but do not
overtighten the jack in the
bracket.
This vehicle has an underbody
mounted tire hoist assembly that
has a secondary latch system. It is
designed to stop the spare tire from
suddenly falling off the vehicle. For
the secondary latch to work, the
spare must be installed with the
valve stem pointing down. See
Storing a Flat or Spare Tire and
Tools under
.
Before beginning this procedure
read all the instructions. Failure to
read and follow the instructions
could damage the hoist assembly
and you and others could get
hurt. Read and follow the
instructions listed next.
To release the spare tire from the
secondary latch:
1. Check under the vehicle to see if
the cable end fitting is visible.
2. If the cable end fitting is not
visible, proceed to Step 6.
If it is visible, first try to tighten
the cable by turning the wheel
wrench clockwise until you hear
two clicks or feel it skip twice.
The cable cannot be
overtightened.
Advertisement
Table of Contents
