Electrolux EWF 1010 Instruction Booklet page 17

7. Start the programme
Depress START/PAUSE button, the corresponding
pilot light stops flashing. The "door" pilot light
illuminates and only the pilot light
remains lit.
8. Altering a programme
You can alter the programme before it starts.
When the programme has started, you can only
reset it by turning the programme selector dial to O
and then you can select the new programme.
The water in the tub will not be emptied out.
Start it by depressing the START/PAUSE button.
9. Interrupting a programme
Depress the START/PAUSE button to interrupt a
programme which is running, the corresponding
light starts to flash. Depress the same button again
to restart the programme.
10. Cancelling a programme
Turn the selector dial to O to cancel a programme
which is running.
Now you can select a new programme.
11. Opening the door after the
programme has started
First set the machine to pause by pressing the
(start pause) button. If the
flashes and after 2 minutes goes off, the door can
be opened.
If the (door) light doesn't flash, this means that
the machine is already heating, that the water level
is above the bottom edge of the door or that the
drum is turning.
In this case the door can not be opened.
If you can not open the door but you need to open it
you have to switch the machine off by turning the
selector dial to "O". After about 3 minutes the door
can be opened (pay attention to the water level and
temperature!).
12. At the end of the programme
The machine stops automatically.
If the Rinse Hold
/
must be emptied out before opening the door.
To do this turn the programme selector dial to "O"
and then to programme
speed. In order to avoid any creasing in synthetic,
delicate and wool items, the spin speed can be
reduced by means of the relevant selector.
The door can only be opened after the pilot
light
Switch the machine off by turning the programme
selector dial to "O".
Remove the laundry from the drum and carefully
check that the drum is empty so as to avoid any
forgotten items being damaged in a subsequent
wash (e.g. shrinking) or their colour running into a
load of whites.
If you do not intend to carry out another wash, close
the water tap.
Leave the door open to prevent the formation of
mildew and unpleasant smells.
(door) light
17
option has been selected,
the End and Door
the door locked light is on to indicate that the water
The spin programme is performed at the maximum
has gone out.
pilot light remains lit and
(drain) or (spin).