Water Connection - Jacuzzi 1.6 GALLON Installation Instructions Manual

One piece toilet

Hide thumbs

Table Of Contents

Table of Contents

1. Before connecting the water supply, flush the line into a bucket to remove any debris.

2. Place the coupling nut, friction washer and universal washer onto the plain end of

supply tube as shown.

NOTE: The same universal washer will be used to

make the flanged slip-joint connection for a 1/2" O.D.

or 3/8" flexible, or a 3/8" I.P.S. supply.

3. Temporarily make connection to tank supply shank,

finger-tight. Mark at shut-off valve the tube length

needed and add 1/4". (This will insert down into shut-

off valve).

4. Remove supply tube and cut to length including the

extra 1/4". Remove any burrs from inside the cut

end. Slip compression nut and ring (ferrule) onto the

shut-off valve end of the tubing.

5. Connect supply tube to supply shank once more and

finger-tighten. Tubing may be pushed up into tank

supply to allow the extra 1/4" to be inserted into shut-off valve.

6. Tighten both the coupling nut at the tank and the compression nut at the shut-off

valve. Make sure float valve does not rotate while tightening the coupling nut. The

float ball must not contact the tank walls.

7. Turn on water supply and shut-off valve. Check for leaks. An additional tightening

adjustment on leaking connections normally will stop the leak.

Adjustment (A)

1. WATER LEVEL IN TANK

Turn the water level adjustment screw clockwise to

lower or counter-clockwise to raise the water level

to the waterline mark on the tank.

2. TANK REFILL

Turn Flow Control screw clockwise to slow or

counter-clockwise to speed-up the rate of tank fill.

NOTE: If either screw is turned clockwise too far, the

float valve may not activate.

3. FLAPPER ADJUSTMENT

The length of the chain that connects the lever arm to the flapper may need to be

adjusted. (Move the hook to another link)

A) TOO MUCH SLACK may not permit the flapper to lift far enough to properly

activate the flush valve.

B) NOT ENOUGH SLACK in the chain may keep the flapper from closing properly.

3. REFILL TUBE

Make sure the refill tube is properly inserted in the top of the flush valve.