Disassembly - Golden Technologies Companion Owner's Manual

Companion Owner's Manual: GC222, GC223, GC322, GC323, GC325, GC421
1. REMOVING THE SEAT
NOTE: Pinchless seat hinges are standard on
all Golden Companion scooters.
1. Loosen the adjustment knobs. See figure 13.
2. Slide the arms off the scooter.
3. Remove the seat by lifting it straight up and
out of the seat post.
4. The seat can be folded for compact storing.
2. DISCONNECTING THE TAILLIGHT CONNEC-
TOR
1. Open the trunk lid. See figure 13.
2. Disconnect the taillight connector. See figure
14.
3. REMOVING THE REAR SHROUD
1. Pull up on the right and left sides of the shroud
near the front end. See arrows in figure 15.
2. Lift the shroud up and off the scooter. See figure
15 A.
PULL UP HERE
FIGURE 15. REMOVING THE REAR SHROUD
Companion

DISASSEMBLY

LOCATING PIN
LOCATING PIN HOLE
PULL UP HERE
ADjUSTMENT
KNOBS
FIGURE 13. REMOVING THE SEAT
DISCONNECT THIS CONNECTOR
FIGURE 14. TAILLIGHT CONNECTOR
(TRUNK LID REMOVED)
MOUNTING
TABS
SLOT
SLOT
FIGURE 15 A
TRUNK LID
(HINGED)
PULL UP ON BOTH SIDES
17