Cleaning The Drum; Clean Operating Screen And Housing - AEG LAVATHERM 59800 User Information

9. Insert the filter mat in the frame
and then insert with the frame into
the filter housing.
1
Important: The filter mat must en-
gage tightly with the frame. Check
that the mat is sitting snuggly in
the frame, especially after inserting
it into the filter housing.
10. Insert holder into the filter hous-
ing.
11. As necessary, approx. once every 6
months, remove the fluff from the
heat exchanger using the sponge
supplied. When doing this, please
use rubber gloves.
Tip: The fluff can be removed more
easily if it is first dampened e. g.
with a laundry dampener.
12. Re-insert filter housing with holder
and filter mat in the base of the appliance.
Note: If the holder and filter mat are not inserted in the filter housing,
the filter housing cannot be pushed into the base of the appliance.
13. Close door in plinth.
3
The indicator CLEAN FILTER BASE only goes out when the programme
knob has been positioned to OFF.

Cleaning the drum

1
Caution! Do not use abrasives or steel wool to clean the drum.
3
Lime in the water or cleaning agents may form a barely visible lining on
the inside of the drum. The degree to which the laundry has been dried
is then no longer detected reliably. The laundry is damper than expect-
ed when removed from the dryer.
Use a damp cloth, which has been soaked in water and a little vinegar,
to wipe the inside of the drum and drum ribs.

Clean operating screen and housing

1
Caution! Do not use furniture cleaners or aggressive cleaning agents to
clean the machine.
Use a damp cloth to wipe down the operating screen and housing.
20