Taillamps, Turn Signal, And Stoplamps - GMC 2006 Envoy Owner's Manual

General motors company 2006 automobile owner manuals
Hide thumbs Also See for 2006 GMC Envoy:
Table of Contents

Advertisement

6. Remove the bulb that needs to be replaced by
turning the socket counterclockwise.
7. Replace the old bulb with a new one using care not
to touch the glass with your fingers.
8. Reinstall by reversing Steps 1 through 6.
Taillamps, Turn Signal, and
Stoplamps
To replace a stoplamp/taillamp or turn signal bulb, do
the following:
1. Open the liftgate. See Liftgate/Liftglass on
page 2-13 for more information.
3. Pull the assembly away from the vehicle.
2. Remove the
two screws from
the taillamp
assembly.
4. Unclip the wiring harness (A) and remove the
three socket retaining screws (B).
5. Remove the socket by releasing the retaining tabs.
6. Holding the socket, pull the bulb to release it from
the socket.
7. Push the new bulb into the socket until it clicks.
8. Reinstall the socket and screws.
9. Reconnect the wiring harness.
10. Reinstall the taillamp assembly and tighten the
screws.
11. Close the liftgate.
5-51

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Envoy xl 2006Envoy xl denali 2006

Table of Contents