Specifications; Operation - Ryobi EHT150RG Owner's Operating Manual

cord that is designed for outside use.
Some dust created by power sanding, sawing, grinding,
drilling, and other construction activities contains
chemicals known to cause cancer, birth defects or other
reproductive harm. Some examples of these chemicals
are:

lead from lead-based paints

crystalline silica from bricks and cement and
other masonry products, and

arsenic and chromium from chemically-treated
lumber
Your risk from these exposures varies, depending on
how often you do this type of work. To reduce your
exposure to these chemicals: work in a well ventilated
area, and work with approved safety equipment, such
as those dust masks that are specially designed to fi lter
out microscopic particles.

SPECIFICATIONS

Input
No-load speed
Collet
Weight

OPERATION

Do not allow familiarity with products to make you
careless. Remember that a careless fraction of a
second is suffi cient to infl ict serious injury.
Always wear eye protection marked to comply with
ANSI Z87.1. Failure to do so could result in objects
being thrown into your eyes resulting in possible
serious injury.
Do not use any attachments or accessories not
recommended by the manufacturer of this product. The
use of attachments or accessories not recommended
can result in serious personal injury.
WARNING
240 V 50 Hz
10,000-35,000 (RPM) min
3.2 mm max.
0.54 kg
WARNING
WARNING
WARNING
English
APPLICATIONS
You may use this product for the purposes listed below:

Cutting

Sanding

Polishing and buffing

Engraving

Drilling
TURNING THE ROTARY TOOL ON/OFF
See Figure 2.
 To turn the tool on: Push " | ".
 To turn the tool off: Push " O ".
To prevent damage to the spindle or spindle lock,
always allow motor to come to a complete stop before
engaging the spindle lock.
CHANGING COLLETS
See Figure 3.
 Unplug the rotary tool.
 Press and hold the spindle lock, and rotate the shaft
with the provided collet wrench until the spindle lock
-1
engages the shaft, preventing further rotation.
 With the spindle lock engaged, use the collet wrench
to loosen the collet nut, if necessary.
 Remove the collet nut and old collet using collet
wrench, if necessary.
 Insert the unslotted end of the collet in the hole in the
end of the tool shaft.
 Replace the collet nut on the shaft.
Always use the collet which matches the shank size
of the accessory you plan to use. Never force a large
diameter shank into a collet. The accessory should
fi t smoothly into the collet, but you should be able to
tighten the accessory fi rmly and securely with the
provided wrench.
If you are changing an accessory immediately after
use, be careful not to touch the collet, collet nut, or
the accessory with your hands or fi ngers. You will
get burned because of the heat build-up from cutting.
Always use the wrench provided.
3
CAUTION
WARNING
DANGER