Electrolux EDC 77150 W User Manual page 10

125983630 gb.qxp 2006-10-02
10 electrolux use
Select the Delay Start
With the DELAY button, you can delay the start of
a programme by between 30 minutes (30' and a
maximum of 20 hours (20H).
1.Select the programme
2.Press the DELAY button as many times
as necessary until the required start delay appears
on the multi display, e.g. 12H if the programme is
to be started in 12 hours.
If 20H is displayed and you press the button again,
the time delay will be cancelled. The display will show
0' and then the duration of the selected pro-
gramme.
3.To acti v ate the del a y ti m er, press the START/PAUSE
button. The amount of time remaining until the
programme is set to start is continuously dis-
played (e.g. 12H, 11H, 10H, ... 30' e+tc).
If you wish to add some laundry while the
machine is performing the countdown, after
having done so and having closed the door,
press START/PAUSE again, in order to allow
the machine to complete the remaining
countdown time.
Display
The display shows the following information:
D D u u r r a a t t i i o o n n o o f f s s e e l l e e c c t t e e d d p p r r o o g g r r a a m m m m e e
After you have selected the programme,
its duration (in hours and minutes) appears
on the display. It is calculated automatically
on the basis of the maximum load
accepted for each type of fabric and of the
required degree of drying.
When the programme starts, the remaining
time is displayed every 5 minutes.
12:39 Page 10
D D e e l l a a y y e e d d s s t t a a r r t t
If you have selected a delay time by means of
the relevant button, the display shows it for 3
seconds; then it shows the duration of the
previously sel e cted programme. The
countdown is displayed every 30 minutes
until it displays "90 minutes" and then hour by
hour.
E E n n d d o o f f p p r r o o g g r r a a m m m m e e
A flashing zero indicates the end of the
programme and it is displayed after the
"anticreasing" phase.
I I n n c c o o r r r r e e c c t t o o p p t t i i o o n n s s e e l l e e c c t t i i o o n n
If you select an option that is not compatible
with the programme you have selected,
the display shows Err (error).
This code will reappear during the execution of
the programme if you press one of the option
buttons or turn the programme selector.
A A l l a a r r m m c c o o d d e e
In case of a functional anomaly, the display
shows an alarm code (e.g. E21).
" " D D r r y y i i n n g g " "
This symbol appears on the dispay that
the appliance is in the drying phase.