Page 5
_Water temperature _Number of dives _Log: last 14 dives GETTING STARTED Thank you for choosing Suunto Elementum Aqua, a digital sports watch for diving. To get started: 1. Press any button to activate the watch. 2. Keep [A] pressed to enter .
Page 6
0.6 m. In mode, Suunto Elementum Aqua starts recording dive your dive time when it reaches a depth more than 1.2 m. • When surfacing, Suunto Elementum Aqua saves dive information into memory and starts showing surface time.
Page 7
MEMORY 1. In mode, rotate [A] to enter time memory 2. Rotate [A] upwards/downwards to browse the dive logs. 3. Press [A] to switch between the first and second view of the dive log. 4. Press [B] to exit. BUTTON LOCK Press [A] and [B] at the same time in any mode to activate/open the button lock.
Before you go on to read the manual itself, it is extremely important that you read the following warnings. These warnings are intended to maximize your safety while using Suunto Elementum Aqua and must not be ignored. WARNING: Read this manual. Carefully read this instruction manual in its entirety paying close attention to all warnings listed here.
Page 11
replace the need for proper diving training. Insufficient or improper training may cause diver to commit errors that may lead to serious injury or death. WARNING: Use back-up instruments. Make sure that you use back-up instrumentation including a depth gauge, submersible pressure gauge, timer or watch, and have access to decompression tables whenever diving with a bottom timer.
[B]. The TIME DIVE device switches automatically to mode when in contact with water. DIVE Change the settings of your Suunto Elementum Aqua in . View your SETTINGS diving logs in MEMORY 2.1 Changing general settings To change the general settings: 1.
TIP: You can exit at any time by keeping [A] pressed or by pressing SETTINGS [B]. You can change the following general settings on your Suunto Elementum Aqua: ● alarm: on/off ● alarm time: hours and minutes ● time format: 12h/24h ●...
2.3 Using button lock The button lock can be activated in both modes. To activate the button lock: 1. Press [A] and [B] at the same time. When the button lock is activated, only the backlight works. 2. To open the button lock, press [A] and [B] at the same time. 2.4 Activating backlight The backlight can be activated in both modes.
Page 15
NOTE: If you want to use the backlight in , activate it before MEMORY SETTINGS entering them. NOTE: Heavy use of the backlight significantly reduces battery life.
DIVE water and reaches depth more than 0.6 m. The symbol on the display indicates water contact. After you reach depth more than 1.2 m, Suunto Elementum Aqua automatically starts recording your dive time.
3.3 During diving During diving (depth more than 1.2 m), the following information is displayed: ● dive time (first row) ● current depth (second row) ● maximum depth of the dive (bottom row) ● water temperature (outer rim) 3.4 Between dives When you reach depth less than 1.2 m, the device saves the dive information (log) into and starts to count surface time.
NOTE: The minimum time for a dive log is 15 s: shorter logs are not saved. When is full, a new log replaces the oldest log. MEMORY NOTE: The maximum surface time shown in the counter is 48 hours. After that, the counter is reset in addition to the dive time and max.
Page 19
The information on your diving logs is stored into . Each log has its MEMORY own memory slot that is shown as a segment on the outer rim on the display. The log information is divided into two views. In the first view (picture 2), the following information is shown: ●...
NOTE: Do not use detergents or solvents of any kind as they might cause damage to the unit. Do not try to repair the unit yourself. Contact an authorized Suunto service, distributor, or retailer for any repairs. Suunto Elementum Aqua is tested according to the ISO standard 6425. This means that the product is water-resistant to 200 m.
5 SPECIFICATIONS 5.1 Technical specifications General ● Operating temperature: -10 °C to +60 °C / -2°F to +140°F ● Storage temperature: -30 °C to +60 °C / -22°F to +140°F ● Water resistance: 200 m / 600 ft (ISO 6425) ●...
Suunto brand trademarks and names are registered or unregistered trademarks of Suunto Oy. This document and its contents are proprietary to Suunto Oy and are intended solely for the use of clients to obtain knowledge and information regarding the operation of Suunto products.
5.5 Disposal of device Please dispose of the device in an appropriate way, treating it as electronic waste. Do not throw it in the garbage. If you wish, you may return the device to your nearest Suunto representative.
If, however, you purchased the Product in a member state of the European Union, Iceland, Norway, Switzerland, or Turkey, and Suunto originally intended the Product for sale in one of these countries, this Limited Warranty is valid and enforceable in all of these countries. The warranty service may be limited due to the possible country-specific elements in the Products.
(1) year. To the extent your national laws permit, the Warranty Period will not be extended or renewed or otherwise affected due to subsequent resale, Suunto authorized repair or replacement of the Product. However, part(s) repaired or...
4. the Product has been exposed to influence from chemical products including (but not limited to) mosquito repellents. Suunto does not warrant that the operation of the Product will be uninterrupted or error free, or that the Product will work in combination with any hardware or software provided by a third party.
When the Product or a part is replaced, any replaced item becomes the property of Suunto. If a refund is given, the Product for which the refund is given must be returned to a Service Center as it becomes the property of Suunto and/or Service Center.
Page 28
Suunto knew of the likelihood of such damages. Suunto shall not be liable for delay in rendering service under the limited warranty, or loss of use during the time...