Electrolux EDC 5339 Instruction Booklet page 15

125981580 gb.qxp 2005-09-21
8. Press the «Options» button to select the required
options.
To confirm your choice press the «Change»
button.
Depending on the selected programme only
certain options are available and shown
during the selection phase.
Note: Not all the options are compatible
between themselves. The incompatible option
icons will disappear.
9. Select the DELAY START option if required.
Before you start the programme choose the
required option.
The selected delay time value (up to 20 hours) will
appear on the display while selecting.
The end cycle will be updated and shown on the
relative position of the display.
10.Press the START/PAUSE
light will stop flashing. The message relevant to
the phase that is in progress will be shown in the
display.
If you have chosen a delayed start, the tumble
dryer will begin the countdown.
If the programme selector dial is turned to
another position, when the machine is running,
the buzzer will sound and the «Selection error»
message appears in the display.
The drum turns alternately in both directions
during drying.
All drying programmes end with a 10 minute
cooling phase (on the second row of the display
appears the «Cooling» message).
You may remove the laundry after this phase.
The display shows the following messages one
07:08 Page 15
button. The relevant
after an other: «Please clean the filters» and
«Please empty the tank». The buzzer sounds to
indicate the end of the cycle.
11.If the laundry is not removed at the end of the
cycle, the dryer performs an anti-creasing phase
(duration: 30 minutes maximum).
If you do not remove the laundry, the dryer will
stop automatically at the end of the anti-creasing
phase. The display will show the following
messages one after an other: «Anticrease»,
«Please clean the filters» and «Please empty
the tank».
The buzzer sounds to indicate the end of the cycle.
The light of the START/PAUSE
off and a flashing zero appears on the display.
12.Turn the programme selector dial to "O"; all the
lights go out. The appliance is switched off.
Remove the laundry.
If you open and then close the door before
turning the programme selector dial to "O",
the machine is ready to perform another
drying programme. The display shows the
selected programme, duration of the
programme and the options required.
After each use
• Clean the filters (see page 17).
• Empty the water reservoir (see page 18).
Important!
If the drying programme has to be stopped before it
reaches the end, we recommend that you turn the
programme selector dial to position «Cooling» and
wait until the end of this phase before removing the
laundry. This will avoid a build-up of heat inside the
appliance. To do this first turn the dial to «O» and
then to «Cooling» and press Start/Pause
Modifying the programme
To change a programme which is running, first
cancel it by turning the programme selector dial to
«O». Select the new programme and press the
Start/Pause button .
15
button goes
button .