Table of Contents
Advertisement
To set a different level, proceed as follows:
1. Press the "Intensive 70°C" and "BIO 50°C" programme push buttons simultaneously for
about 5 seconds. The pilot light corresponding to the current level flashes.
2. Press within 5 seconds the programme push button corresponding to the required level.
After 5 seconds the dishwasher will memorise the new level setting and will return to
programme setting mode.
The setting will remain memorised after switching off the dishwasher.
SO409
Filling with special salt
Caution! The packaging of dishwasher salt and detergents are often very similar. The
accidental filling of the salt compartment with detergent would ruin the water softener. Each
time you add salt, make sure the carton you have in your hand really is salt.
Only use salt specifically designed for use in dishwashers.
All other types of salt not specifically designed for use in a dishwasher,
especially table salt, will damage the water softener.
Only fill with salt just before starting one of the complete washing
programmes (not the "Rinse and hold" programme). This will prevent any
grains of salt or salty water, which may have been spilled, remaining on the
bottom of the machine for any period of time, which may cause corrosion.
To fill:
1. To fill with salt, unscrew the cap of the salt container.
2. Pour 1 litre of water inside the container (this is
necessary only before filling with salt for the first
time).
3. Using the funnel provided, pour in the salt until the
container is full.
Do not worry if water overflows from the unit when
filling with salt, this is quite normal.
4. Replace the cap making sure that there is no trace of
salt on the screw thread or on the gasket.
5. Screw on the cap tightly.
When this has been done, all that is required is to periodically top up the container with salt.
You are reminded of this by the salt indicator light on the control panel which will illuminate
when the salt has finished.
10
SR14
Advertisement
Table of Contents
