Care And Cleaning; Cleaning Materials; Cleaning The Outside Of The Appliance; Cleaning Inside The Oven/Grill - Electrolux EOB 949 User Manual

CARE AND CLEANING

BEFORE CLEANING THE APPLIANCE
ALWAYS ALLOW THE COOLING FAN TO
COOL THE APPLIANCE DOWN BEFORE
SWITCHING OFF
SUPPLY.

CLEANING MATERIALS

Before using any cleaning materials on your
appliance, check that they are suitable and that their
use is recommended by the manufacturer.
Cleaners that contain bleach should NOT be used as
they may dull the surface finishes. Harsh abrasives
should also be avoided.
CLEANING THE OUTSIDE OF THE
APPLIANCE
DO NOT use abrasive cleaning materials e.g. Hob
Brite, Brillo pads or scourers on painted or printed
finishes as damage may occur. Regularly wipe over
the control panel and oven door using a soft cloth
and hot water to which a little washing up liquid has
been added.
DO NOT ATTEMPT TO REMOVE ANY OF THE
CONTROL KNOBS FROM THE PANEL AS THIS
MAY CAUSE DAMAGE AND IS A SAFETY
HAZARD.
Under no circumstances should the door
assembly be detached from the product for
cleaning. Please refer to the cleaning
instructions.
THE ELECTRICITY

CLEANING INSIDE THE OVEN/GRILL

The Stayclean surface inside the Oven should not be
cleaned manually. See page 29 'Care of Stayclean
Surfaces'.
The vitreous enamel oven base can be cleaned using
normal oven cleaners or aerosol oven cleaners with
care. Ensure that the manufacturers instructions are
followed and that all parts are well rinsed afterwards.
Aerosol cleaners must not be used on Stayclean
surfaces and must not come into contact with
elements or the door seal as this may cause
damage.
REMOVING AND REPLACING WIREWORK
SIDE RUNNERS
Remove all shelves and furniture from the oven.
Always ensure the telescopic runners are pushed
back into place in the oven cavity. Hold the bottom of
the wirework runners and draw the runners towards
the centre of the oven. Unhook from the top and
remove.
BRACKET
The wirework telescopic runners should not be
placed in a dishwasher. Dry carefully after washing
in hot water to which washing up liquid has been
added. If heavily soiled mild abrasives may be used.
To replace the runners, hook the wirework side
runner into the cavity, slide back and press into
place. Ensure the wirework runners are firmly in
position before replacing the oven shelves.
34
CAVITY CENTRE