Parking Brake - Volvo V70 Owner's Manual

General
Function
A faint electric motor noise can be heard
when the electrical parking brake is being
applied. The noise can also be heard during
the automatic function checking of the park-
ing brake.
If the car is stationary when the parking brake
is applied then it only acts on the rear wheels.
If it is applied when the car is moving then the
normal foot brake is used, i.e. the brake acts
on all four wheels. Brake function changes
over to the rear wheels when the car is almost
stationary.
Low battery voltage
If the battery voltage is too low then the park-
ing brake can neither be released nor applied.
Connect a donor battery if the battery voltage
is too low, see page 124.
Applying the parking brake
Parking brake control - apply.
1. Press the foot brake pedal down firmly.
2. Press the control PUSH LOCK/PULL
RELEASE.
>
The combined instrument pan-
el's symbol starts flashing - once there
is a constant glow the parking brake is
applied.
3. Release the foot brake pedal and make
sure that the car is at a standstill position.
•
When parking the vehicle, always engage
1st gear (for manual gearbox) or put the
gear selector in position P (for automatic
gearbox).
03 Your driving environment
Emergency brake
In an emergency the parking brake can be
applied when the vehicle is in motion by
pressing and holding the control for PUSH
LOCK/PULL RELEASE. The braking proce-
dure is stopped when the control is released.
NOTE
In the event of emergency braking at
speeds above 10 km/h a signal sounds
during the braking procedure.
Parking on a hill
If the car is parked facing uphill:
•
Turn the wheels away from the kerb.
If the car is parked facing downhill:
•
Turn the wheels towards the kerb.
WARNING
Always apply the parking brake when
parking on a slope - leaving the car in
gear, or in P if it has automatic transmis-
sion, is not sufficient to hold the car in all
situation.

Parking brake

03
145