Performing A Washing Cycle; Brief Instructions; Loading The Washing - AEG LAVAMAT W 1270 Instruction Book

Performing a Washing Cycle

Brief Instructions

A washing cycle is performed in the following steps:
0 1.Open the door, load the washing.
2. Close the door.
3. Add detergent/conditioner.
4. Set the correct washing program:
– Set the program on the program selector;
– Set the temperature on the temperature selector;
– In the case of easy-care washing: Press the
button.
5. Press the
The washing machine is switched on. The washing program starts.
6. If necessary, change the spin speed or select rinse hold.
You can alter this setting and the temperature during the entire
washing cycle.
At the end of the washing program:
Important! If the washing cycle ends with a rinse hold, perform either
(PUMP OUT),
the door.
3
For safety reasons, the door remains locked for 1-2 minutes after the
end of the program.
7. Open thedoor, remove the washing.
8. Press the
The washing machine is switched off.

Loading the Washing

3
For maximum loads see the "Program Tables". For notes on the correct
preparation of the washing, see "Washing Types and Care Symbols".
1.Sort and prepare washing according to type.
0
2. Press and release the outer door in area of the sticker
left (top right for doors hinged on the left). The outer door will spring
open.
(ON/OFF) button.
(SPIN) or
(ON/OFF) button.
Operating instructions
(EASY-CARES)
(SHORT SPIN) before opening
on the top
17