AEG LAVAMAT W 1050 ELECTRONIC User Information page 28

Operating Instructions
Problem
The washing
machine vibrates
when operating,
or is noisy.
Excessive foaming
during the main
wash.
Water leaks out
of the washing
machine.
Fabric softener was
not rinsed in, the
æ compartment is
filled with water.
28
Possible cause
Transit packaging was not
removed.
The machine is not level.
There is very little washing in
the drum (for example one
dressing gown).
Water could not be fully
drained out before spinning
because the drain hose is
kinked or the water pump is
blocked.
Probably too much detergent
has been used
The screw connection of the
inlet hose is leaking.
The drainage hose is leaking.
The drain pump cover is not
correctly closed.
Washing is caught in the door.
The emergency emptying hose
is not correctly closed or is
leaking.
The insert in the conditioner
compartment is not correctly
attached or is blocked.
Remedy
Remove the transit packaging
as described in the Installation
and Connection instructions.
Adjust the feet according to
the Installation and
Connection instructions.
This does not affect the
operation of the machine.
Check the drain hose and
remove any kinks if necessary
or clean the water pump and if
necessary remove any foreign
bodies from the pump
housing.
It may be necessary to reduce
the amount of detergent used.
Follow the detergent
manufacturer's
recommendations.
Tighten the inlet hose screw
connection.
Check the drainage hose and
replace if necessary.
Close the cover correctly.
Stop the programme, remove
the washing caught in the
door. Restart the programme.
Close the emergency emptying
hose (see Section "Carry out
emergency emptying").
Call your local Service Force
Centre if the emergency
emptying hose is leaking.
Clean the detergent dispenser
drawer and attach the
conditioner insert correctly.