Rear Panel - Sony HDC-900 Series Product Information Manual

7
HDC-900/950/930 Series Product Information Manual
7-1-2

Rear Panel

1 Video signal select buttons
2 POWER indicator
3 ND filter selector
4 CC filter selector
5 FILTER LOCAL button
6 UP TALLY switch
7 VF SCAN switch
8 SCREEN SIZE MARKER switch
9 CENTER MARKER switch
1
ed INTERCOM PROD/ENG switch
ef INTERCOM volume control
eg PGM 1/2 switch
eh PGM volume control
ej MIC ON/OFF switch
a Video signal select buttons
Select the video output signal (R, G, or B) to the
viewfinder. The R, G, and B buttons may be pressed
individually or in combination. The signal
corresponding to each pressed button will be output.
When two buttons are pressed, the output of will
consist of those two signals mixed together.
The video output to the monitor connected to the TEST
OUT connector will always be the Y signal regardless
of these buttons.
When a color viewfinder is used:
• When all three buttons are pressed, the output to the
viewfinder and monitor will be the Y signal.
• When no button is pressed, the output to the
viewfinder will be the color signals and to the monitor
will be the Y signal.
POWER
R G B
RET 2
2 3
1
FILTER LOCAL H-POSI V-POSI
2 3 4
1 5
ON
ND
STORE
UP TALLY CURSOR
B C D WIDTH HEIGHT
ON
A E
1
CC
OFF
VF SCREEN SIZE CENTER SAFETY
DISPLAY MENU SELECT
SCAN MARKER MARKER ZONE
16:9 ON ON ON
ON
OFF
CANCEL ENTER
4:3 OFF OFF OFF MENU
ea VF connector
Memo clip
MIC MIC
ENG PROD OFF ON ENG PROD OFF ON
1 2 1 2
INTERCOM PGM INTERCOM PGM
INTERCOM 1
b POWER indicator
This indicator lights up or goes off as follows to indicate
the power supply status:
Green: Power is being supplied to the HDC-900.
Red: The CAM PW button of the MSU-700A/750
Master Setup Unit or RCP-700 series Remote
Control Panel is set to OFF.
Yellow: Power is being supplied to the HDC-900, but
the VF PW button of the MSU-700A/750 Master
Setup Unit or RCP-700 series Remote Control Panel
is set to OFF, and power is not being supplied to the
viewfinder.
Off: Power is not being supplied to the HDC-900.
Chapter 7 Location and Function of Parts and Controls
e; H-POSI control
wl WIDTH control
wk V-POSI control
wj HEIGHT control
wh CURSOR ON button
wg CURSOR STORE button
wf RET 2 button
wd RET 1 button
RET 1
ws RETURN SELECT knob 2
2 3
4 4
1
wa RETURN SELECT knob 1
M S
EMORY TICK
w; Memory stick section
1
ql Back tally lamp
2 3
VF DETAIL qk CURSOR 1, 2, and
ON
3 buttons
CALL
OFF
qj CALL button
qh VF DETAIL control
qg VF DETAIL switch
qf Assignable switch
qd MENU SELECT control
qs MENU SELECT switch
qa DISPLAY switch
q; SAFETY ZONE switch
es INTERCOM 1 and 2 connectors
INTERCOM 2
ej MIC ON/OFF switch
eh PGM volume control
eg PGM 1/2 switch
ef INTERCOM volume control
ed INTERCOM PROD/ENG switch
79