Stanley 30SS Owner's Manual page 9

Clearing A Clogged Chute—Safety Precautions
1. SHUT THE ENGINE OFF!
2. Wait at least 10 seconds to be sure the augers have
stopped rotating.
3. Always use a cleanout tool and never your hands.
4. Ground the spark plug when clearing if hands get
close to the augers/impeller.
IMPORTANT! The snow blower belts are adjusted
to ensure the augers/impeller stop turning within
five (5) seconds of releasing the impeller control
lever. If you are making any belt adjustments
whatsoever, for your safety and the safety of others
around you, you must ensure the belts are re-
adjusted to achieve this design specification.
DANGER: Do not bypass, modify, alter or
disconnect the safety system. Make sure
that the safety interlock system is fully
operational each time before operating the
.
machine
Before attempting to use your snow blower,
make sure you are familiar with all of the
components and have read the manual.
V7.10.24.12
Operation Safety Precautions
4
Do NOT over-prime the engine. Pressing the
primer bulb more than 3x could result in flooding
the carburetor making the engine hard to start
or cause fuel to leak from the carburetor inlet.
GASOLINE IS HIGHLY FLAMMABLE AND
EXPLOSIVE. FUEL LEAKS, A LOOSE FUEL TANK,
OR A LOOSE FUEL VALVE CAN LEAD TO
SEVERE INJURY OR DEATH. DO NOT OPERATE
THIS SNOW BLOWER IF ANY COMPONENT OF
THE FUEL SYSTEM IS LOOSE OR LEAKS
GASOLINE!
Before setting up your SNOW BEAST snow
blower, disconnect the spark plug wires from
the spark plugs and ground them against the
engine to prevent inadvertent starting. This
step should be taken as a precaution
whenever you are working on this machine.
Check engine oil level before each use.
Maintain oil level between run marks on the
dipstick, and change oil according to the
maintenance schedule to maximize product life.
Need Help?
Parts, Service
and Technical Assistance call:
(919)-550-3259
Monday-Friday 8AM-5PM EST
www.beastpowerequipment.com
30SS, 36SS, 45SS