How To Activate The Rinse Aid Dispenser; Technical Data - AEG FAVORIT 50874 User Manual

22

Technical data

Problem
Dry water drop stains on
glasses and dishes.
The dishes are wet.
The dishes are wet and dull.

How to activate the rinse aid dispenser

1. Switch on the appliance.
2. Make sure that the appliance is in setting mode.
3. Press and hold function buttons B and C.
– The indicator lights for function buttons A, B, and C start to flash.
4. Release function buttons B and C.
5. Press function button B.
– The indicator lights for function buttons A and C go off.
– The indicator light for function button B continues to flash.
– The display shows the current set.
6. Press function button B again.
– The display shows the new adjustment.
7. Switch off the appliance to keep the operation.
Technical data
Dimensions
Water supply pressure
Water supply
Capacity
1) Connect the water inlet hose to a water tap with a 3/4'' thread.
Rinse aid dosage is too low.
The detergent can be the cause. Use a different brand of deter-
You have set a washing pro-
gramme without drying phase
or with a decreased drying
phase.
The rinse aid dispenser is emp-
ty.
The multitab function is on.
(The rinse aid dispenser is au-
tomatically off).
Width
Height
Depth
Minimum
Maximum
1) Cold water or hot water
Place settings
Possible cause
Rinse aid dispenser deactivated
Rinse aid dispenser activated
Possible solution
Increase the rinse aid dosage.
gent.
Let the door stay ajar for some
minutes before you remove the
dishes.
Fill the rinse aid dispenser with
rinse aid.
Activate the rinse aid dispenser.
Refer to 'How to activate the
rinse aid dispenser'.
0,5 bar (0,05 MPa)
8 bar (0,8 MPa)
maximum 60 °C
596 mm
850 mm
625 mm
12