Helpful Hints And Tips - Electrolux EWS106110W User Manual

Before you make any change, you must
PAUSE the appliance by pressing the button
5 .
Changing a running programme is possible
only by resetting it. Turn the programme se-
lector dial to O and then to the new pro-
gramme position. Start the new programme
by pressing the button 5 again. The washing
water in the tub will be not emptied out.
Interrupting a programme
Press the button 5 to interrupt a programme
which is running, the corresponding green
pilot light starts blinking.
Press the button again to restart the pro-
gramme.
Cancelling a programme
Turn the selector dial to
gramme which is running.
You can select now a new programme.
Opening the door
After the programme has started (or during
the delay time) the door is locked, if you need
to open it, set first the machine to PAUSE by
pressing the button 5 . After a few minutes it
will be possible to open the door.
If the door remains locked, this means that
the machine is already heating or that the
water level is too high. In any case, do not
force the door!
If you cannot open the door but you need to
open it you have to switch the machine off by
turning the selector dial to O . After a few mi-
nutes the door can be opened (pay atten-
tion to the water level and tempera-
ture!) .
Stand by : once the programme has fin-
ished after a few minutes the energy sav-
ing system is enabled with the pilot lights

Helpful hints and tips

Sorting out the laundry
Follow the wash code symbols on each gar-
ment label and the manufacturer's washing
instructions. Sort the laundry as follows:
whites, coloureds, synthetics, delicates,
woollens.
to cancel a pro-
After closing the door, it is necessary to se-
lect the programme and options again and to
press button 5 .
At the end of the programme
The machine stops automatically. The pilot
light of button 5 and the pilot lights corre-
sponding to the finished phases go out. The
7.3 light illuminates to indicate that the cycle
is finished. In a few minutes it will be possible
to open the door.
If a programme or an option that ends with
water left in the tub has been selected, the
door remains locked. The water must be
emptied out before opening the door.
Follow the below instructions to empty out
the water:
1. Turn the programme selector dial to O .
2. Select the draining or spinning pro-
gramme.
3. Reduce the spin speed if needed, by
pressing the relevant button.
4. Press button 5 .
At the end of the programme, the pilot light
7.3 illuminates to indicate that the cycle is
finished. The door can be now opened. Turn
the programme selector dial to O to switch
the machine off.
Remove the laundry from the drum and care-
fully check that the drum is empty. If you do
not intend to carry out another wash, close
the water tap. Leave the door open to pre-
vent the formation of mildew and unpleasant
smells.
switched on. By pressing any button the
appliance will come out of the energy
saving status.
Before loading the laundry
Never wash whites and coloureds together.
Whites may lose their «whiteness» in the
wash.
New coloured items may run in the first wash;
they should therefore be washed separately
the first time.
electrolux 9